Citroën Xantia

since 1993 release

Repair and operation of the car



Citroën Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ Repair of the engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
- Body and finishing of salon
   Care of components of a body and bottom of the car
   Care of an upholstery and carpets of salon
   Repair of insignificant damages of body panels
   Repair of seriously damaged body panels
   Removal and installation of a front bumper
   Removal and installation of a rear bumper
   Removal, installation and adjustment of a cowl
   Removal and installation of a driving cable of an otpuskaniye of the lock of a cowl
   Removal and installation of locks of a cowl
   Removal, installation and adjustment of doors
   Removal and installation of panels of an internal upholstery of doors
   Removal and installation of door handles and components of the lock
   Removal and installation of regulators of window regulators of door windows
   Removal, installation and adjustment of a door of a back and its telescopic emphasis
   Removal and installation of components of the lock of a door of a back
   Removal and installation of components of the uniform lock
   Removal and installation of components of the electric drive of door window regulators
   Removal and installation of door rear-view mirrors and the accompanying components
   Windshield, glass of a door of a back and the other fixed glasses - the general information
   The top hatch - the general information
   Exterior body finish
   Removal and installation of seats
   Removal and installation of seat belts
   Removal and installation of elements of internal finishing of salon
   Removal and installation of the central console
   Removal and installation of the dashboard
   Control body sizes
+ Onboard electric equipment
+ Schemes of electric equipment


04d84ca1



Removal, installation and adjustment of doors

Removal

 PERFORMANCE ORDER

1. On models with laid in door panels by an electrical wiring perform the following procedures:
   a) Disconnect a negative wire from the battery;
   b) Remove the panel of an internal upholstery of a door and the sealing screen (see Removal and installation of panels of an internal upholstery of doors);
   c) Through an opening in a doorframe disunite contact sockets of an electrical wiring and release a plait(s) of wires from all provided clamps. Try to remember a route of laying of a plait(s);
   d) Release the rubber plug of a plait through passage of wires from a forward end face of a door and pass an electrical wiring through an opening in a frame.

2. Otboltite from a body rack the limiter of opening of a door.

3. Ask the assistant to support a door, or prop up door sideways a jack through wooden whetstone.

4. Having made sure of reliability of fixing of a door, to an otboltita also take axial fingers of both loopy assemblies. Remove a door.

Installation

Installation is made upside-down. Pay attention to the next moments:
   a) Do not forget to grease axial fingers of loopy assemblies with assembly lubricant;
   b) At the corresponding complete set track correctness of laying of a plait(s) of an electrical wiring and reliability of fastening of contact sockets;
   c) The description of procedures installation of the sealing screen and panel of an internal upholstery of a door is provided in the section Removal and installation of panels of an internal upholstery of doors.

Adjustment

Adjustment demands from the performer of rather high qualification and certain skills, and therefore, its performance will be more correct to be charged to specialists of car service.


On the homepage